Dell Brocade Adapters - Manual (Page 30)

2 Brocade Adapters Installation and Reference Manual
53-1002144-01
Fabric Adapters
1
FIGURE 2 Brocade 1860 Fabric Adapter (heat sink removed)
ATTENTION
Only use Brocade-branded SFP+ laser transceivers supplied with stand-up Fabric Adapters.
AnyIO technology
Although the Brocade 1860 can be shipped in a variety of SFP configurations, you can change port
function to the following modes using the Brocade AnyIO technology, provided the correct SFP is
installed for the port:
• HBA or Fibre Channel mode. This mode utilizes the Brocade Fibre Channel storage driver. An 8
or 16 Gbps Fibre Channel SFP can be installed for the port. The port provides Host Bus Adapter
(HBA) functions on a single port so that you can connect your host system to devices on the
Fibre Channel SAN. Ports with 8 Gbps SFPs configured in HBA mode can operate at 2, 4, or 8
Gbps. Ports with 16 Gbps SFPs configured in HBA mode can operate at 4, 8, or 16 Gbps.
Fabric Adapter ports set in HBA mode appear as “FC” ports when discovered in HCM. They
appear as “FC HBA” to the operating system.
NOTE
Fibre Channel mode and HBA mode may be used interchangeably in this document.
1 LEDs for port 1 SFP
2 Cable connectors for port 1 and port 0 SFPs (Fiber optic SFP illustrated)
3 LEDs for port 0 SFP
4 Low-profile mounting bracket.
Note: The adapter ships with the standard (full-height) mounting bracket
installed.
5 PCIe x8 connector
6 ASIC
2
3
1
4
5
6