Dell Brocade Adapters User Manual
Page 217
Brocade Adapters Installation and Reference Manual
189
53-1002144-01
Host Bus Adapters
5
ATTENTION
For stand-up HBAs, use only Brocade-branded SFP laser transceivers supplied with this product.
Cable connector
(stand-up adapters)
LC
ASIC
•
Provides the Fibre Channel functionality for all
HBA models.
•
Two on-board processors, each operating at
400 MHz, generate signal timing and link
protocol in compliance with Fibre Channel
standards.
External serial FLASH
memory
•
Stores firmware and HBA BIOS code
•
4 MB capacity
Data Rate
Per Port - Full Duplex
•
1600 MB at 8 Gbps
•
800 MB at 4 Gbps
•
400 MB at 2 Gbps
Performance Per Port
500,000 IOPs (maximum)
Distance Support
(stand-up adapters)
50 m at 8 Gbps with 62.5/125 micron multimode
fiber
Topology Point-to-Point
(N_Port)
Protocols
•
SCSI over FC (FCP)
•
FCP3 - initiator mode only
•
FC-SP Authentication
•
NPIV
Other Features
•
ASIC Flip-flops Parity Protected
•
ECC Memory Parity Protected
•
Quality of Service (QoS)
•
Target Rate Limiting
•
Boot Over SAN
•
Fabric-Based Boot LUN Discovery
•
I/O Interrupt Coalescing
•
T10 Data CRC
•
Multiple Priority (VC_RDY)
•
Frame-Level Load Balancing
•
Persistent Binding
•
Fabric-Based Configuration
TABLE 26
Supported Fibre Channel features (continued)
Feature
Description