Dell Latitude D630 ATG (Mid 2007) User Manual

Page 133

Advertising
background image

Adding and Replacing Parts

133

NOTE:

Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.

To replace the hard drive in the hard drive bay:

1 Follow the procedures in "Before You Begin" on page 115.

NOTE:

The number of hard drive screws may vary.

2 Remove the hard drive screws on the bottom of the computer.

NOTICE:

When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting

Against Electrostatic Discharge" in the Product Information Guide.

3 Slide the hard drive out of the computer.
4 Remove the new drive from its packaging.

Save the original packaging for storing or shipping the hard drive.

NOTICE:

Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the

connector.

5 Slide the hard drive into the bay until it is fully seated.
6 Replace and tighten the screws.
7 Use the Operating System media to install the operating system for your computer (see "Using the

Operating System Media" on page 112).

Use the Drivers and Utilities media to install the drivers and utilities for your computer (see "Reinstalling

Drivers and Utilities" on page 108).

1 screws (2)

2 hard drive

1

2

Advertising