Dell UPS 10000R - Manual (Page 51)

51 Configuring the Card |
NOTE: If the hostname is not used, the IP address supplied by the DHCP server must be assigned through Static
DHCP Assignment to maintain the connection with the clients installed on the stations to be protected.
NOTE: During the first connection, if the DHCP query is not successful, the Dell Network Management Card
starts with the following IP configuration:
IP Address: 192.168.1.2
Subnet Mask: 255.255.255.0
Gateway Address: 0.0.0.0
S
Firmware Upload: Authorizes (choose Enabled) remote updating of the card's embedded software.
The default value for this parameter is Enabled.
S
Primary DNS Server: Contains the IP address of the main DNS server ensuring conversion of the
domain name to IP address.
S
Secondary DNS Server: Contains the IP address of the secondary DNS server ensuring conversion
of the domain name to IP address if the primary DNS server is not available.
S
SMTP Server (for Email Notification): Contains the name or IP address of the local server with
which the card connects to send e-mail messages. You can fill in the field either as host + domain
name (DNS resolution) or directly with the IP address.
The default value is smtpserver. The card uses the standard port (25) for sending e-mail messages.
S
SMTP server authentication (optional): To select this option, enter the SMTP server user name
and password.
For security purposes, you must click Save and enter the admin user name and password to save
modifications or run commands. The default user name and password are both admin.
Reboot the card after any changes to these parameters (see the following section, “System Settings”).