Dell OptiPlex 9010 All In One (Mid 2012) - Manual (Page 11)

2
Removing and Installing Components
This section provides detailed information on how to remove or install the components from your computer.
Recommended Tools
The procedures in this document may require the following tools:
• Small flat-blade screwdriver
• Phillips screwdriver
• Small plastic scribe
Removing the Video Electronics Standards Association (VESA)
Stand
1. Follow the procedures in Before Working Inside Your Computer .
2. Place the computer on a flat surface, display side facing downwards.
3. Using a plastic scribe, release the cover starting with the notches at the bottom.
NOTE: To avoid damaging the VESA stand cover, handle the plastic scribe with care.
4. Lift the VESA cover upwards and away from the computer.
11