Installing the optical drive, Removing the hard drive – Dell OptiPlex 9010 All In One (Mid 2012) User Manual
Page 20
Installing the Optical Drive
1.
Place the optical-drive bracket on the optical drive.
2.
Tighten the screws that secure the optical-drive bracket to the optical drive.
3.
Align and slide the optical drive into its slot.
4.
Connect the optical-drive cable.
5.
Tighten the screws that secure the optical drive to the computer.
6.
Install the:
a) VESA mount bracket
b) back cover
c) VESA stand
7.
Follow the procedures in
After Working Inside Your Computer
.
Removing the Hard Drive
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the:
a) VESA stand
b) back cover
c) VESA mount bracket
3.
Unthread the cables from the notches on the hard-drive bracket. Disconnect the hard-drive cables from the hard
drive.
4.
Remove the screw that secures the hard-drive bracket to the system board. Slide and lift the hard-drive bracket
away from the computer.
5.
For a 2.5–inch hard drive, remove the screws that secure the hard drive to the hard-drive bracket. Slide the hard
drive from the hard-drive bracket. Remove the screws that secure the hard-drive case to the hard drive.
20