Dell OptiPlex 9010 All In One (Mid 2012) - Manual (Page 48)

Option Description
USB Configuration This field configures the integrated USB controller. If Boot Support is enabled, the
system is allowed to boot any type of USB mass storage devices (HDD, memory key,
floppy).
If USB port is enabled, device attached to this port is enabled and available for
operation system.
If USB port is disabled, the operation system cannot see any device attached to this
port.
• Enable Boot Support
• Enable Front USB Ports
• Enable Rear Dual USB Ports
• Enable Rear Triple USB Ports
Miscellaneous Devices Allows you to enable or disable various on-board devices.
• Enable/Disable Microphone
• Enable/Disable Camera
• Enable/Disable Media Card
Table 4. Security
Option Description
Admin Password This field lets you set, change, or delete the administrator (admin) password
(sometimes called the setup password). The admin password enables several
security features.
The drive does not have a password set by default.
• Enter the old password
• Enter the new password
• Confirm the new password
Click OK after entering the password details.
System Password Allows you to set, change, or delete the computer password (previously called the
primary password).
The drive does not have a password set by default.
• Enter the old password
• Enter the new password
• Confirm the new password
Click OK after entering the password details.
Internal HDD-0 Password Allows you to set, change, or delete the password on the computer's internal hard
disk drive (HDD). Successful changes to this password take effect immediately.
The drive does not have a password set by default.
• Enter the old password
• Enter the new password
• Confirm the new password
Click OK after entering the password details.
48