Dell OptiPlex 9010 All In One (Mid 2012) - Manual (Page 41)

Installing the Display Panel
1. Tighten the screws that secure the display brackets to the display panel.
2. Align the display assembly over the middle frame.
3. Connect all the touchscreen-board cables to the connectors on the display panel.
4. Affix the tape that adheres the connectors to the display panel.
5. Align the chassis over the display panel and tighten the screws to secure the chassis to the middle frame.
6. Replace the screws that secure the chassis to the middle frame.
7. Connect the LVDS cable to its connector and connect any other cables or antennae around the edges of the base
panel.
8. Install:
a) system board
b) antenna module
c) speakers
d) processor fan
e) heat-sink assembly
f) power supply unit
g) power-supply fan
h) converter board
i) power-button board
j) intrusion switch
k) hard drive
l) optical drive
m) WLAN card
n) input/output board shield
o) system-board shield
p) VESA mount bracket
q) back cover
r) VESA stand
9. Follow the procedures in After Working Inside Your Computer .
Removing the Antenna Modules
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the:
a) VESA stand
b) back cover
c) VESA mount bracket
d) system-board shield
e) input/output board shield
f) WLAN card
g) optical drive
h) hard drive
i) intrusion switch
j) power button board
k) converter board
l) processor fan
41