Two Brothers Racing Polaris RZR 800 User Manual
Page 3
ITBR001-185
2008-10 Polaris RZR - 3
Fi
gu
re
A
Fi
gur
e B
Fi
gu
re
C
unplug
connector
unplug
connector
unplug
The ignition must be turned OFF before installation.
1
Remove both seats.
2
Remove the plastic panel behind the seats.
3
Locate the injector harness connectors as shown in Figure A.
The injector harness connectors are located next to the ignition coils.
4
Unplug the injector harness connectors.
5
Attach the Juice Box Pro connectors to the injector harness and stock wiring harness
as shown in Figure B.
6
Locate the grey 3-pin throttle position sensor (TPS) connector as shown in Figure C.
The TPS connector is located to the rear of the throttle body.
7
Unplug the TPS connector.
Note:Figure C was taken with the bed removed. This connector can be accessed
without removing the bed.