Two Brothers Racing Suzuki SV-1000 User Manual

V.a.l.e, Juice box™ - fuel controller

Advertising
background image

Two Brothers Racing

Juice Box™ - Fuel Controller

2005-08 Suzuki SV1000 Installation & Operation Manual

Part # 008-102

Parts Incuded

Installation Instructions

Qty.

Description

Part Number

1

Juice Box™ Fuel Control Kit

008-102

3

Zip Ties

1

Adhesive Velcro Square

V.A.L.E.

V a r i a b l e a x i s l o c k i n g e x h a u s t

TM

Route the harness down the RH frame. connect ground to

the negative post of the battery. (Fig 5)

Route harness over rear cylinder head and down the left

side of the throttle body. (Fig 6)

Locate the throttle body harness connector, it’s between

the LH frame and airbox. Reach in through the LH frame

opening, find and disconnect. Pull the JUICE BOX™

harness connector out through the frame opening.

Connect the JUICE BOX™ harness to the throttle body

harness. Connect the JUICE BOX™ harness to the main

harness. Place a screwdriver on the back of the connector

(Fig 7) to hold it. Reach in through the frame opening and

connect the JUICE BOX™. (Fig 8)

6.

7.

8.

9.

IMPORTANT - PLEASE READ CAREFULLY

Warranty

two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original

defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers

racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.

to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of

original purchase.

We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance part,
please consult with your local motorcycle dealer. Read all instructions first before
starting installation. Make sure the vehicle and exhaust system are completely cool
before starting the installation. Also, make sure the vehicle is secure during installation.
Be sure to save all stock components for possible use later.

The Juice Box™ is legal ONLY for closed course race vehicles. The Juice Box™ is not
applicable, nor inteded for use on EMISSIONS CONTROLLED street, highway or off-road
vehicles. The Juice Box™ is not applicable, nor inteded for use on aircraft.

Thank you for purchasing a genuine Two Brothers Racing

JUICE BOX™. This product represents a radical step

forward in tuning fuel-injected motorcycles and ATVs for

optimal performance using “load-based” technology.

We at Two Brothers Racing hope that you will find this

development as exciting and useful as we do. And

remember: Proper Fuel = Maximum Power!

Make sure the vehicle is completely cool before starting

the installation. Also, make sure the vehicle is secure and

will not roll around.

Remove side panel screws, side panels. (Fig 1)

Remove seat mount hardware, seat. (Fig 2)

Remove front tank mount hardware, lift and support tank.

(Fig 3)

Locate JUICE BOX™ in the tail section. (Fig 4)

1.

2.

3.

4.

5.

Continued on page 2

Fig 1

Fig 5

Fig 2

Fig 3

Fig 4

Fig 6

Fig 7

Fig 8

Advertising