Two Brothers Racing 2006 Yamaha R1 User Manual

V.a.l.e, Juice box™ - fuel controller, Two brothers racing

background image

Two Brothers Racing

Juice Box™ - Fuel Controller

2006 Yamaha R1 Installation & Operation Manual

Part # 008-113-06C

Parts Incuded

Installation Instructions



Part Number


Juice Box™ Fuel Control Kit

008-113-06C (#9140084C)


Zip Ties


Adhesive Velcro Square


V a r i a b l e a x i s l o c k i n g e x h a u s t


Once both trim panels have been removed the left and

right fuel tank hold down bolts can be removed (fig 6)

Tilt the fuel tank up and support with foam block from

Two Brothers Exhaust system packaging. (fig 7)

Locate four grey injector connectors at the rear of the air

box, under the fuel rail. (fig 8)

Remove grey injector connectors one at a time and

connect JUICE BOX™ grey connectors to injectors and

connect JUICE BOX™ black connectors to stock grey

connectors. Repeat this step for all four injectors. (fig 9)

Loosen the ground lug on the battery (negative or black

lead) and connect the JUICE BOX™ black ground lead

with ring terminal to the ground lug on the battery.

Tighten the battery ground lug.








two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original

defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers

racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.

to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of

original purchase.

We recommend that this performance part be installed by a qualified motorcycle

technician. If you have any doubts as to your ability to install this performance part,

please consult with your local motorcycle dealer. Read all instructions first before

starting installation. Make sure the vehicle and exhaust system are completely cool

before starting the installation. Also, make sure the vehicle is secure during installation.

Be sure to save all stock components for possible use later.

This Juice Box is legal for use on Emissions Controlled street and highway vehicles.

The Juice Box™ is not applicable, nor inteded for use on aircraft.

Thank you for purchasing a genuine Two Brothers Racing

JUICE BOX™. This product represents a radical step

forward in tuning fuel-injected motorcycles and ATVs for

optimal performance using “load-based” technology.

We at Two Brothers Racing hope that you will find this

development as exciting and useful as we do. And

remember: Proper Fuel = Maximum Power!

Make sure the vehicle is completely cool before starting

the installation. Also, make sure the vehicle is secure and

will not roll around.

Start by removing rear seat. (fig 1)

Remove to bolts at rear of the front seat and remove front

seat (fig 2)

Remove bolt at front and center of fuel tank (fig 3)

Remove both Phillips screws at the right rear and left rear

of fuel tank lower trim panels. The panel is an interlock

type, slide front to back to release. (fig 4 & 5)






Tools Needed For Install

- Phillips Screwdriver
- 5mm, 6mm Allen Wrench

Continued on page 2

Fig 1

Fig 2

Fig 3

Fig 6

Fig 7

Fig 4

Fig 5

Fig 8

Fig 9