Sony DCR-VX700 - Manual (Page 55)

1 Tk’ouble Check
1 i voii 1 iin into any problem using the c. amcordei', use the lollou nig nib'e It) tr<'uble>hoot thi‘ problem.
Camcorder
Power
Symptom Cause and/or Corrective Actions
1 1 k ' power is not on. • Insert llie batter\'pack, 'p .''i
• Tlie batter\' is de<ui
Use a charged batteiA eack (p. n'
• Connect the AC power ad.iplor to a wall outlet, (p. 20)
The power goes off. • While being operated in C .\\1i:R.A mtide, the camcorder has
been in the Standb\' mode tor more than 5 minutes.
Turn STANDEE down tmce and turn it up again, (p. 12)
The battery pack is quickly
discharged. • The batterv is dead.
Use a charged battcTN pack. (p. o)
• TI k * ambient temperature i" too low. (p. 30)
• Charge the batter\' pack again, (p. oi
• The batterv pack is complctelv dead and cannot be
recharged.
Use another batter'.’ pack. (p. 31)
Operation
Symptom Cause and/or Corrective Actions
START/STOP does not operate. • The tape is stuck to the drum.
-> Eject the tape, ip.^)
• Rewind the tape or u>e a neu- one (p. 17)
• Set the I’OWER switch to CAMERA, (p. 11)
• The tab on the cassette is out (red). 4
Use a new tape or slide the tab. tp. 10)
• Set the Standby switch to ST.'W'DBV. (p. 11)
The cassette cannot be removed from tlie
holder. • Insert the batter\’pack. tp.
• The batterv is dead.
•> Use a charged batterv pack or the .AC power adaptor.
(p. 6,20)
'
No function except for cassette ejection
^yorks. • Moisture condensation has occurred.
Remove the cas^ette and leave the camcorder for at least
an hour. (p. 5.3)
The tape does not move when a tape
transport button is pressed. • Set the POWER switch to
\
TR. (p. 17)
• Rewind the tape or use a new one. (p. 17)
• The camcorder is updating the cassette memory
data (The cassette memory mounted miniDV
cassette only).
Eject the cassette after C MEMORY indicator disappears,
{p. 9)
The STEADY SHOT function does not
activate. • Set STliAD'i' SHOT to 0\ ip. 40)
n
Q}
3
>
cr
57