Sony SAT-A4 - Manual (Page 14)

TV and VCR
Your VHF/UHF IN jack may he labeled as
RF IN.
Refer to the illustration on the opposite page.
1 Connect the RG-6 cable from the Satellite Antenna's LNB to the
Digital Satellite Receiver's SATELLITE IN jack.
2 Complete one of the following to connect the Digital Satellite
Receiver:
□ Better Connection: Connect the Digital Satellite Receiver's A/V
jacks to the A/V IN jacks on the TV and VCR. If your VCR has
only one AUDIO IN jack (monoaural VCR), connect it to the
lower AUDIO L (mono) jack on the Digital Satellite Receiver.
□ Good Connection: Connect the Digital Satellite Receiver's
VHF(SAT)/UHF OUT jack to the VCR's VHF/UHF IN jack.
3 Complete one of the following to connect the VCR to the TV:
□ Better Connection: If both your TV and VCR have A/V jacks,
connect the VCR's A/V OUT jacks to the TV's A/V IN jacks.
□ Good Connection: If your TV or VCR has only an RF jack,
conned the VCR's VHF/UHF OUT jack to the TV's VHF/UHF
IN jack.
4 Cormect one end of the telephone line cord to the Digital Satellite
Receiver's TEL LINE jack. Connect the other end to your home's
modular telephone outlet. Do not connect to a "wireless"
telephone extension. Since these devices typically do not support
high data rates, connecting to one may result in very slow
operation or may even prevent connection with your program
provider.
5 Cormect one end of the AC power cord to the Digital Satellite
Receiver's AC IN jack. Connect the plug end to an AC outlet.
Optional Connections
□ If you have a cable input, cable box, or a terrestrial TV antenna,
connect it to the TV or VCR's VHF/UHF IN jack.
□ Best Connection: If your TV has an S-VIDEO jack, use an S-VIDEO
cable to connect the Digital Satellite Receiver's S-VIDEO jack to the
TV's S-VIDEO IN jack. This provides the best picture quality. Then
use audio cables to connect one set of the Digital Satellite
Receiver's audio jacks to the TV's AUDIO IN jacks.
□ You can also connect the Digital Satellite Receiver to your audio
receiver's AUDIO IN jacks using audio cables.
□ If you are using the IR Blaster, see page 18 for setup instructions.
Note
If the screen appears fuzzy, the program you are watching may be protected by
Macrovision. Turn the VCR off to improve the picture quality.
14