Setting up the rf antenna (sat-a4 only), To set up the rf antenna – Sony SAT-A4 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Up the RF Antenna (SAT-A4 Only)
Do not place the RF antenna directly on
top of the Digital Satellite Receiver or any
other metal object. For best results, place
the RF antenna in a visible location.
The RF (radio frequency) antenna enables the remote control to operate
the Digital Satellite Receiver even if the Digital Satellite Receiver is
"^located in another room or is placed behind a cabinet door.
Note
You must set up the RF antenna if you plan on using the RF feature.
To set up the RF antenna:
1
Connect the RF antenna to the Digital Satellite Receiver's RF
REMOTE jack.
2
Place the RF antenna at least one foot away from the Digital
Satellite Receiver.
3
Use the on-screen displays to set up the Digital Satellite Receiver to
accept RF transmission (RF ONLY). See "Setting Up the Remote
Control" on page 71 for details.
The Digital Satellite Receiver is shipped with IR transmission enabled
and RF transmission disabled. To use the RF feature, you must first
change the factory setting (IR ONLY) to the RF setting (RF ONLY)
using the on-screen displays, as described on page 71.
The operating range of the remote control
is about too ft. This may decrease due to
ambient radio wave conditions, your
room's walls, weak batteries, etc.
19