Sony SAT-A4 - Manual (Page 72)

Setting the Security Code
(SAT-A4 Only)
If the Digital Satellite Receiver is accepting or receiving signals from
another RF remote control in your home (or from a neighbor's house),
you can eliminate this problem by changing the security codes for the
Digital Satellite Receiver and remote control.
J^ote
/Is an alternative, you can eliminate this problem by disabling the RF
capability of the Digital Satellite Receiver, if you have no need for RF
transmission. See “Selecting IR/RF Transmission (SAT-A4 Only)" on page 71
for details.
There are tw'o steps to changing the RF security code: Step 1 is
changing the Digital Satellite Receiver's security code; step 2 is
changing the remote control's security code. Both the Digital Satellite
Receiver and the remote control must use the same three-digit security
code.
The Digital Satellite Receiver and
remote control are shipped with the RF
security code set to 000.
Step 1: Select the Digital Satellite Receiver's RF Security Code
1
2
Select REMOTE CONTROL from the Setup Menu.
Select RF SECURITY CODE and then select a different security
code.
SET UP REMOTE
REMOTE SIGNAL
REMOTE CODES
3
4
IR ONLY
RE SECURITY CODE
Select the RE security
code for the Digital
Satellite Receiver.
CODE 001
CODE 002
CODE 003
CODE 004
T
OK
CANCEL
IDENTIFY
HELP
Select OK to save your changes and return to the Setup Menu.
Go to "Step 2: Set the Remote Control's RE Security Code" on page
73 to continue.
72