Compaq P5000 Series - Manual (Page 178)

178
FRAMING ERROR, 144
HAM. COIL OPEN *, 144
HB NOT INSTALLD *, 144
ILL EXT BUS ACC *, 144
ILL INST ACCSS *, 145
ILLGL OPR ACCSS *, 144
INTAKE FAN FAULT, 145
LO DRV. SHORT *, 144, 145
LOAD PAPER, 145
PAP BAD TABLE *, 145
PAP BSY TOO LNG *, 145
PAP FIFO OVERFL *, 145
PAP FIFO UNDRFL *, 145
PAP ILLGL ST *, 145
PAP INCMPL ENER *, 145
PAP INVLD CMD *, 145
PAP INVLD PARM *, 145
PAP NOT SCHED *, 145
PAP NT AT SPEED *, 145
PAP UNEXP INT *, 145
PARITY ERROR, 145
PLAT INV CMD *, 146
PLAT INV PARM *, 146
PLAT INV STATE *, 146
POWER SAVER MODE, 146
POWERSUPPLY HOT *, 146
PRINTER HOT *, 146
PROTECTED INSTR *, 146
PWRSUPP VOLT *, 146
RIB INVLD CMD *, 146
RIB INVLD STAT *, 146
RIBBON DRIVE, 146
RIBBON INK OUT, CHANGE RIBBON, 146
RibbonMinder, 153
SECURITY VIOLATION, 146
SHUTL INV CMD *, 147
SHUTL INV PARM *, 147
SHUTTLE JAM, 147
SOFTWARE ERROR *, 147
STACK OVERFLOW *, 147
STACK UNDERFLOW *, 147
TCB CORRUPTED *, 147
UNDEF INTERRUPT *, 147
UNDFNED OPCODE *, 147
UP DRV. SHORT *, 147
15V PWR FAIL *, 143
23.5V PWR FAIL *, 143
48V PWR FAIL *, 143
8.5V PWR FAIL *, 143
Features list
diagnostic tools, 14
host interfaces supported, 11
printer emulations supported, 11
text and graphics formatting, 13
FF Valid at TOF, 83
FIRMWARE ERROR message, 144
Font Attributes, 79
Font Set, 101
Format conventions, 9
Forms
slewing
speed, 113
thick perforations See Open Platen @ BOF
parameter, 113
Forms Length, 81
Forms Width, 81
Framing error handling, 132
FRAMING ERROR message, 144
G
Graphics
IGP options, 13
Graphics Options, 96
H
Hammer bank
line matrix printing, 15
HAM. COIL OPEN * message, 144
Handshaking, IEEE 1284 interface, 127
Hardware installation
unpacking instructions
adjusting paper supports
cabinet model, 24
pedestal model, 30
attach output basket