Compaq P5000 Series - Manual (Page 34)

34
Chapter 2 Install Basic Components
Install Basic Components
The following section gives instructions on essential procedures which keep
your printer operational on a day-to-day basis.
Connect the Interface and Power Cables
Before you connect the interface and power cables, verify the voltage source
at the printer site conforms to the requirements specified on page 17. Make
sure the printer power switch is set to OFF (see Figure 21).
WARNING To prevent serious personal injury from electrical shock when
connecting or disconnecting the host interface (signal) cable, make sure
that the printer is powered off and the power cable is unplugged.
WARNUNG Um ernstliche körperliche Verletzungen durch Stromschlag beim
Anschließen oder Trennen des Signalton-Kabels zu vermeiden, muß der
Drucker auf jeden Fall ausgeschaltet und der Netzstecker
herausgezogen werden.
ATTENTION Afin d'éviter tout risque de blessure par électrocution lors du
branchement ou du débranchement du câble de signal, mettre
l'imprimante hors tension et débrancher le câble d'alimentation.
Figure 20. Cable Connection Locations
Pedestal Model Cabinet Model
Centronics/IEEE
Parallel
Dataproducts
Parallel
RS-232/RS-422
Serial
Diagnostic
Centronics/IEEE
Parallel
Diagnostic
RS-232/RS-422
Serial
Dataproducts
Parallel