Compaq P5000 Series - Manual (Page 55)

Example
55
Changing Parameters
A configuration consists of several parameters. The default factory
configuration has a starting set of parameters. Your print jobs may require
different parameter settings from the default that is provided. This section
provides an example procedure for changing and saving individual parameter
values.
Example
The following procedure shows how to change and save the settings for the
Unidirectional option. Use these basic guidelines to navigate the configuration
menus and change other parameters.
If you think the configuration for your printer has already been changed from
the default, you should load the default configuration before starting this
procedure (page 63).
NOTE: Once you change active emulations, any changes to the previously
selected emulation will be gone unless they have been saved.
. . .
OFFLINE
CONFIG.
CONTROL
PRINTER
CONTROL
Unidirectional PMD Fault Slow Paper
Slew
Power Saver
Time
Disable*
Enable Enable*
Disable Disable*
Enable 15* - 60 Min.
Instant
* = Factory Default
Table 4. Parameter Change Example Procedure
Step Key Result Notes
1. Make sure the printer is on. Raise the printer cover.
2.
3. Allows you to make configuration
changes.
ONLINE
OFFLINE
CONFIG. CONTROL
+
ENTER SWITCH
UNLOCKED
OFFLINE
CONFIG. CONTROL