Compaq P5000 Series - Manual (Page 182)

182
PROTECTED INSTR * message, 146
Protecting a configuration, 61
Protocols
defined, 14
RS-232 serial interface, 131
RS-422 serial interface, 131
selecting, 104
Protocol, serial interface, 104
P-Series Emulation, 86
PWRSUPP VOLT * message, 146
R
RAM, displaying, 115
Rates
printing and plotting, 16
Ready signal
Dataproducts parallel interface, 121
Received data (RD) signal
RS-232 serial interface, 131
RS-422 serial interface, 131
Request to Send parameter, 106
Request to send (RTS) signal
RS-232 serial interface, 131
Requirements
printer, power, 17
Resetting RibbonMinder, 117
Resistors
configuration, 124
installation, 125
removal, 125
Response Polarity
Centronics, 108
RIB INVLD CMD * message, 146
RIB INVLD STATE * message, 146
Ribbon
adjustment, 156
configuration menu, 117
installing, 36
setting size, 155
size parameter, 118
specifications, 157
RIBBON DRIVE message, 146
RIBBON INK OUT, CHANGE RIBBON, 146
RibbonMinder, 149
configuring, 150
display/disable, 153
Fault Action, 156
fault conditions, 154
fault message, 117, 153
new ribbon, 117, 152
ribbon action, 117, 153
ribbon adjust, 118, 156
ribbon size, 118
running a job, 152
set ribbon size, 155
Rot. Char Size, 97
RS-232 serial interface
clear to send (CTS), 131
configuration, 132
data carrier detect (DCD), 131
data set ready (DSR), 131
error handling, 131
framing error handling, 132
overrun error handling, 132
parity error handling, 131
pin assignments, 130
protocol, 131
request to send (RTS), 131
X-ON/X-OFF signal, 131
RS-232 serial interface signals, 131
data terminal ready (DTR), 131
received data (RD), 131
transmitted data (TD), 131
RS-422 serial interface
configuration, 132
error handling, 131
framing error handling, 132
overrun error handling, 132
parity error handling, 131
pin assignments, 130
protocol, 131
X-ON/X-OFF signal, 131
RS-422 serial interface signals
received data (RD), 131
transmitted data (TD), 131
Running self-tests, 138