AVer System Contrll Pro User Manual (NV version) - Manual (Page 13)

7
1.2 Hardware Installation
1.2.1 Connecting with the DVR Server through the USB port
The following is an example of System controller installation.
1. The DVR server should be power on and DVR program is executed.
2. Plug the power cord of the System Controller into power outlet.
3. And then, plug the USB cable that is attached on the System Controller to the USB port of the
DVR server.
4. After hardware installation has completed, please remember system controller function on DVR
server (see also Chapter 2.1 ) and select the correct operating mode on the System Controller
(see also Chapter 2.1.2 ).
i
After System Controller has connected to the DVR system, please wait about 3 minutes for
DVR system to automatically detect and install the System Controller.