AVer System Contrll Pro User Manual (NV version) - Manual (Page 18)

12
Chapter 2 Operating the System Controller Pro
2.1 Using the System Controller for the First Time
For the first time using the System Controller, please enable system controller function on the DVR
server.
1. Start up the DVR program.
2. Click Setup in preview mode.
3. Select System, the System Setting windows will appear.
4. Click Detail that is next to the System Controller section.
5. Mark Enable check box to enable the function of the System Controller.
6. Select the Model as System Controller Pro (USB connection) or System Controller Pro
485(RS485 port connection).
7. For System Controller Pro 485 model, user needs to select the connection Port. If there is more
than one DVR systems are connecting with System Controller, user can assign a DVR ID for the
DVR system as a control identity.
8. Click OK to complete the setting.
9. Please remember to select corresponded operating mode on the System Controller in order to
operate normally.