Detex DTX-2300 - Manual (Page 8)

Prox.pad Installer Guide
Document # 6-055678 X2 Page 8 of 32
Performing a Glass Mounted Installation
Figure 3 below shows the four supplied pressure-sensitive adhesive pads and the two side cut-outs used for this installation.
In this confi guration, the prox.pad unit is affi xed with the four self-adhesive pads to the glass or the glass window adjacent
to the door being accessed, on the interior side of the glass. One of the two side cut-outs is used to bring the wires out of
the side of the prox.pad case.
A typical glass mounted installation proceeds as follows:
1. Disconnect the back housing from the front keypad/ controller. Remove the tape from the four self-adhesive pads
on the back housing and apply the pads to the four corners of the backplate.
2. Affi x the back housing to the glass door or the glass window adjacent to the door being accessed, on the interior
side of the glass.
3. Determine which of the two side cut-outs on the back housing to use for the wiring and remove that cut-out using
the appropriate cutting tool.
4. Pull the wiring through the selected side cut-out as required.
5. Connect the front keypad/controller to the back housing.
6. Install the tamper screw into the hole at the bottom front of the enclosure using a #6 spanner bit.
Figure 3: Performing a Glass Mounted Installation