Figure 4, Laser data module – ETS-Lindgren HI-6100 Field Monitor User Manual
Page 23
Advertising
Assembly and Installation
|
23
Figure 4: Laser Data Module
1.
Remove the cover by removing the two screws on the back panel and
the nut on the laser data module angle bracket, if installed.
2.
Place the new module in the desired channel location and secure with
two screws on the back panel and the nut on a laser data module
angle bracket, if available.
3.
Attach one end of the data module cable to the data module and the
other end to the corresponding channel and data module interface
board.
Advertising