Frame-fabrication-typea – Oldcastle BuildingEnvelope ICR-225 User Manual
Page 9
6
March 2012
Phone: 1-866-OLDCASTLE (653-2278)
Web Address: www.oldcastlebe.com
I C R - 2 2 5 - I N S T A L L A T I O N M A N U A L
1.3
FRAME FABRICATION TYPE “A”
Fabricate vertical/jamb members for head, sill and intermediate horizontal attachment.
SEE FIGURE 6, PAGE 7 .
Drill jig guide:
Align drill jig with top of horizontal. Drill holes outlined below based on the member:
Head Member (DJ-101) – Use holes D,E for 4 1/2” system; D,F for 6” system
Screw Spline Horizontal (DJ-101) – Use holes A,B for 4 1/2” system; A,C for 6” system
(Optional) Shear Block Horizontal (DJ-103) – Use holes A,B for 4 1/2” system; A,C for 6” system
Sill Member (DJ-101) – Use holes G,H for 4 1/2” system; G,I for 6” system
•
•
•
•
If optional shear block horizontal is used (
SEE FIGURE 21, page 20), fabricate hole on each end of
horizontal per
FIGURE 20, page 20.
1.5
Drill 5/16” diameter weep holes in horizontals and sill members at 1/4 points. Install ICR-312 baffle clips
at Horizontals. Install HP-1004 baffles as required at sill, securing with SPW-295 baffle retainers. SEE
FIGURE 7, page 8
.
1.6
Drill one 5/16” diameter weep hole at the bottom center of each lite of glass at the horizontal face caps.
NOTE: For SSG applications, there will be multiple holes per face cap.
1.7
Drill anchor holes in sill members on “V” groove. Head anchors are secured to building condition
before frame is set in place. See approved shop drawings for location and quantity of anchors and
anchor bolt sizes.
4 1/2” system: 600 lbs.
6” system: 1000 lbs. (Type “A”) with optional head reinforcing sleeve
•
•
Maximum end reactions: