QOMO QRF900 User Manual - Manual (Page 105)

Copyright © 2008 -2010 All Rights Reserved by QOMO HiteVision.
www.qomo.com 105
7 The quiz is loaded and
ready but the timer
has not started. Yes Enter
and
send the
answer Receives the message
“Wait to Start”
8 The quiz is loaded and
running,
the timer
started. The student
keypad
joined the
class previously.
Yes Power
Up You can press “Send”
key to directly logon
back to previous class.
The LCD displays the
register screen.
9 The quiz is loaded and
running and the timer
started. Yes Enter
and
send the
answer Displays “Success!”
message.
Note: Before using your student keypad to join a quiz with the pace controlled by the instructor, you
should understand the function operation from using this table.
To join a quiz, follow these steps:
a) Turn on the keypad power. If the scenario is in form 5 or 8, you just need to press the “Send”
key .
b) If you did not join the class previously, you may have to login to the current class and register
for the class.
c) If you joined the current class previously, you may simply press the “Send” key to get a
short cut to directly register for the class.
d) If your keypad ID is not listed in the current class, you may need to set your keypad ID to the
one listed in the class, or try to force a login. The instructor will decide the permission of the
participation.
e)
After you registered the class, follow the instructor‟s quiz pace.

Attending a quiz with self controlled pace
Note: Before using your student keypad to join a quiz in the self controlled pace, you should
understand the function operation forms on the above table before you can begin your quiz.
To join the quiz, follow these steps:
1. If you didn‟t join the class previously, you may have to login to the current class and then
register and join the class.
2. If you joined the current class previously, simply press the “Send” key to get a short
cut to directly register for the class.