Appendix l: multiple vlans with computers, Overview, Rvl200-to-srw2048 configuration – Cisco 4-Port SSL/IPSec VPN Router RVL200 User Manual

Page 102: Rvl200 configuration, Overview rvl200-to-srw2048 configuration, Appendix l, Multiple vlans with computers

Advertising
background image

94

Multiple VLANs with Computers

4-Port SSL/IPSec VPN Router

Appendix L

Port 4: Trunking Port

RVL00

192.168.4.x

Default VLAN1

VLAN2

VLAN3

VLAN4

192.168.3.x

192.168.2.x

SRW048

RVL200 with Multiple VLANs Using Computers

RVL200 Configuration

Physically connect Ethernet port 4 on the RVL200 to a

trunking port on the SRW2048.
Access the web-based utility of the RVL200. (Refer to

“Chapter 4: Advanced Configuration” for details.)
Click the Port Management tab.
Click the Create VLAN tab.

Port Management > Create VLAN

1.

2.

3.
4.

Appendix L:

Multiple VLANs with

Computers

Overview

The 4-Port SSL/IPSec VPN Router (model number: RVL200)

can support multiple Virtual Local Area Networks (VLANs).

The configuration example shows the Router deploying a

Layer 2 managed switch, which deploys three VLANs.
This example uses the Linksys 48-Port 10/100/1000 +

4-Port miniGBIC Switch with WebView (model number:

SRW2048); however, any of the Linksys SRW switches with

802.1Q VLAN support can also be used.

RVL200-to-SRW2048 Configuration

By default, Ethernet ports 1-4 of the RVL200 are set to the

default, VLAN, when the option, Enable VLAN, is selected

on the Port Management > Create VLAN screen.
On the RVL200, configure VLANs 2, 3, and 4. Set Ethernet

port 4 to Trunk mode, and assign VLANs 2, 3, and 4 to

Ethernet port 4. On the SRW2048, configure VLANs 2, 3,

and 4, and then assign ports to the VLANs.

Advertising