Cisco 4-Port SSL/IPSec VPN Router RVL200 - Manual (Page 13)


Installation
4-Port SSL/IPSec VPN Router
Chapter 
Cable Connection
To connect network devices to the Router, follow these
instructions:
Before you begin, make sure that all of your hardware
is powered off, including the Router, computers,
switches, and cable or DSL modem.
Connect your cable or DSL modem’s Ethernet cable to
the Router’s Internet port.
Connect to the Internet Port
Power on the cable or DSL modem.
Connect one end of an Ethernet network cable to
one of the numbered ports on the back of the Router.
Connect the other end to an Ethernet port on a
network device, such as a computer or switch.
Repeat this step to connect more computers or other
network devices to the Router.
Connect to the Network Device
Connect the included power adapter to the Router’s
Power port, and then plug the power adapter into an
electrical outlet.
Connect the Power
The Power LED on the front panel will light up as soon
as the power adapter is connected properly.
Power on your computers and other network devices.
1.
2.
3.
4.
5.
6.
7.