Cisco 4-Port SSL/IPSec VPN Router RVL200 - Manual (Page 60)

Chapter 4 Advanced Configuration
 4-Port SSL/IPSec VPN Router
Select the service you want from the Service pull-down
menu.
Click Next to continue. Click Previous if you want to
return to the previous screen. Click Exit if you want to
exit the Setup Wizard.
Select the Service
For this service, you can select whether or not you want
the Router to keep a log tracking this type of activity.
To keep a log, select Log packets match this access
rule. If you do not want a log, select Not log.
Click Next to continue. Click Previous if you want to
return to the previous screen. Click Exit if you want to
exit the Setup Wizard.
Select the Log
4.
5.
Select the appropriate Source Interface: LAN, WAN, or
Any from the Interface pull-down menu.
Select the Source IP address(es) for this Access Rule. If it
can be any IP address, select Any. If it is one IP address,
select Single and enter the IP address in the Source IP
fields. If it is a range of IP addresses, select Range, and
enter the IP addresses in the Source IP fields.
Click Next to continue. Click Previous if you want to
return to the previous screen. Click Exit if you want to
exit the Setup Wizard.
Select the Source
Select the Destination IP address(es) for this Access
Rule. If it can be any IP address, select Any. If it is one IP
address, select Single and enter the IP address in the
Destination IP fields. If it is a range of IP addresses, select
Range, and enter the IP addresses in the Destination IP
fields.
Click Next to continue. Click Previous if you want to
return to the previous screen. Click Exit if you want to
exit the Setup Wizard.
Select the Destination
6.
7.