Cisco 4-Port SSL/IPSec VPN Router RVL200 - Manual (Page 18)

Chapter 4 Advanced Configuration
0 4-Port SSL/IPSec VPN Router
If you have not set up the e-mail server on the Log tab,
the message, “E-mail cannot be sent because you have
not specified an outbound SMTP server address,” will be
displayed.
If you have set up the mail server but the log has not been
generated due to the Log Queue Length and Log Time
Threshold settings, the message, “E-mail settings have
been configured,” will be displayed.
If you have set up the e-mail server and the log has been
sent to the e-mail server, the message, “E-mail settings
have been configured and sent out normally,” will be
displayed.
If you have set up the e-mail server and the log cannot
be sent to the e-mail server, the message, “E-mail cannot
be sent out, probably use incorrect settings,” will be
displayed.
Setup Tab > Network
The Setup > Network screen shows all of the Router’s basic
setup functions. The Router can be used in most network
setups without changing any of the default values;
however, you may need to enter additional information in
order to connect to the Internet through an ISP (Internet
Service Provider) or broadband (DSL or cable) carrier. The
setup information is provided by your ISP.
Setup > Network
Network
Host Name and Domain Name Enter a host and domain
name for the Router. Some ISPs require these names as
identification. You may have to check with your ISP to see
if your broadband Internet service has been configured
with a host and domain name. In most cases, you can
leave these fields blank.
LAN Setting
The MAC Address of the Router is displayed.
Device IP Address and Subnet Mask The default values
are 192.168.1.1 for the Router’s local IP address and
255.255.255.0 for the subnet mask.
Multiple Subnet Select this option to enable the Multiple
Subnet feature. Then click Add/Edit to create or modify
subnet(s). A new screen appears.
Create or Modify a Subnet
LAN IP Address Enter the LAN IP address.
Subnet Mask Enter the subnet mask.
Click Add to List. Click Save Settings to save your changes,
or click Cancel Changes to undo them. Click Exit to return
to the Network screen.
If you want to modify a subnet you have created, select
it and Make changes.. Click Save Settings to save your
changes, or click Cancel Changes to undo them. Click
Exit to return to the Network screen.
If you want to delete a subnet you have created, select it
and click Delete selected subnet. Click Save Settings
to save your changes, or click Cancel Changes to undo
them. Click Exit to return to the Network screen.
WAN Connection Type
WAN
There are four connection types available: Obtain an IP
automatically, Static IP, PPPoE, and PPTP. Depending on
which connection type you select, you will see various
settings.
Obtain an IP Automatically
If your ISP automatically assigns an IP address, select
Obtain an IP automatically. (Most cable modem