Cisco 4-Port SSL/IPSec VPN Router RVL200 - Manual (Page 36)

Chapter 4 Advanced Configuration
8 4-Port SSL/IPSec VPN Router
Service Management
Service Name Enter a name.
Protocol Select the protocol it uses.
Port Range Enter its range.
Click Add to List. Click Save Settings to save your changes,
or click Cancel Changes to undo them. Click Exit to return
to the Bandwidth Management screen.
If you want to modify a service you have created, select it
and click Update this service. Make changes. Click Save
Settings to save your changes, or click Cancel Changes
to undo them. Click Exit to return to the Bandwidth
Management screen.
If you want to delete a service you have created, select it
and click Delete selected service. Click Save Settings
to save your changes, or click Cancel Changes to undo
them. Click Exit to return to the Bandwidth Management
screen.
Direction Select Upstream for outbound traffic, or select
Downstream for inbound traffic.
Priority Select High, Middle, or Low. High priority
services will share 60% of the total system bandwidth,
while Low priority services will share 10% of the total
bandwidth. The default is Middle.
Enable Select Enable to use this Priority rule.
Click Add to List, and configure as many rules as you
would like, up to a maximum of 50. To delete a rule, select
it and click Delete selected application.
Click Summary to see a summary of the Priority rules. The
Summary screen appears.
Summary (Priority Selected)
To change a rule, click Edit. To update the list, click
Refresh. To return to the Bandwidth Management screen,
click Close.
On the Bandwidth Management screen, click Save Settings
to save your changes, or click Cancel Changes to undo
them.
QoS > QoS Setup
The QoS Setup screen lets you enable QoS and configure
Trust Mode and Class of Service (CoS) settings.
QoS > QoS Setup
QoS Setup
QoS Mode
QoS Mode Select the appropriate mode, Disable or
Basic. The default is Disable, which indicates no priority.
If the Basic mode is selected, the Router will apply the
settings configured on the QoS Setup, Queue Settings, and
DSCP Settings screens.
Trust Mode Default CoS
Configure the Trust Mode and Default CoS priority values
for each LAN port.
Port ID The ID numbers of the Router’s four LAN ports are
displayed in this column.
Trust Mode Select the appropriate mode: None, CoS, or
DSCP. The default is None.