Summary, Ipsec vpn > gateway to gateway, Add a new tunnel – Cisco 4-Port SSL/IPSec VPN Router RVL200 User Manual

Page 43: Chapter 4, Advanced configuration

Advertising
background image

Chapter 4

Advanced Configuration



4-Port SSL/IPSec VPN Router

Summary

Tunnel Used

The number of VPN tunnels being used is

displayed.

Tunnel Available

The number of available VPN tunnels

is displayed.

Tunnel Status

Add New Tunnel

Click Add New Tunnel to add a

Gateway-to-Gateway tunnel. The Mode Choose screen

appears.

Mode Choose

Click Add Now to display the Gateway to Gateway screen.

Proceed to the “IPSec VPN > Gateway to Gateway” section

for instructions. Click Return to return to the Summary

screen.
After you have added the VPN tunnel, you will see it listed

in the table.

No.

It shows the number of the VPN tunnel.

Name

It shows the Tunnel Name that you gave the VPN

tunnel.

Status

This indicates the status of the VPN tunnel.

Phase Enc/Auth/Grp

This shows the Phase 2

Encryption type (DES/3DES/AES-128/AES-192/AES-256),

Authentication method (MD5/SHA1), and DH Group

number (1/2/5) that you chose in the IPSec Setup section.

Local Group

This shows the IP address and subnet mask

of the Local Group.

Remote Group

The IP address and subnet mask of the

Remote Group are displayed here.

Remote Gateway

It shows the IP address of the Remote

Gateway.

Tunnel Test

Click Connect to verify the status of the

VPN tunnel. The test result will be updated in the Status

column. If the tunnel is connected, a Disconnect button

will be available so you can end the connection.

Config.

Click Edit to open a new screen where you can

change the tunnel’s settings. Refer to the “Gateway to

Gateway” section for more information. Click the Trash

Can icon to delete all of your tunnel settings for each

individual tunnel.

Tunnel Enabled

The number of enabled VPN tunnels is

displayed.

Tunnel Defined

The number of defined VPN tunnels is

displayed.

IPSec VPN > Gateway to Gateway

Use this screen to create a new tunnel between two VPN

devices.

IPSec VPN > Gateway to Gateway

Add a New Tunnel

Tunnel No

The tunnel number is 1.

Tunnel Name

Enter a name for this VPN tunnel, such as

Los Angeles Office, Chicago Branch, or New York Division.

This allows you to identify multiple tunnels and does not

have to match the name used at the other end of the

tunnel.

Enable

Check this box to enable a VPN tunnel. (When

you create a VPN tunnel, this check box will be disabled.)

Local Group Setup

Local Security Gateway Type

Select the type you want to use: IP Only, IP + Domain

Name(FQDN) Authentication, IP + E-mail Addr.(USER

Advertising