Appendix i: gateway-to-gateway vpn tunnel, Overview, Before you begin – Cisco 4-Port SSL/IPSec VPN Router RVL200 User Manual

Page 90: Configuration of the rvl200, Appendix i, Gateway-to-gateway vpn tunnel

Advertising
background image

8

Gateway-to-Gateway VPN Tunnel

4-Port SSL/IPSec VPN Router

Appendix I

Appendix I:

Gateway-to-Gateway VPN

Tunnel

Overview

This appendix explains how to configure an IPSec VPN

tunnel between two VPN Routers by example. Two

computers are used to test the liveliness of the tunnel.

Before You Begin

The following is a list of equipment you need:

Two Windows desktop computers (each computer will

be connected to a VPN Router)
Two VPN Routers (4-Port SSL/IPSec VPN Router, model

number: RVL200, and 10/100 8-Port VPN Router,

model number: RV082) that are both connected to the

Internet

Any VPN Router can be deployed, such as the Linksys

10/100 16-, 8-, or 4-Port VPN Router (model numbers:

RV016, RV082, or RV042); however, this example uses the

RV082.

Configuration when the Remote Gateway

Uses a Static IP Address

This example assumes the Remote Gateway is using a

static IP address. If the Remote Gateway uses a dynamic

IP address, refer to “Configuration when the Remote

Gateway Uses a Dynamic IP Address.”

RVL200

WAN: A.A.A.A

LAN: 192.168.5.1

RV082

WAN: B.B.B.B

LAN: 192.168.1.1

Gateway-to-Gateway IPSec VPN Tunnel - Remote Gateway Using

Static IP

NOTE:

Each computer must have a network

adapter installed.

Configuration of the RVL200

Follow these instructions for the first VPN Router,

designated RVL200. The other VPN Router is designated

the RV082.

Launch the web browser for a networked computer,

designated PC 1.
Access the web-based utility of the RVL200. (Refer to

“Chapter 4: Advanced Configuration” for details.)
Click the IPSec VPN tab.
Click the Gateway to Gateway tab.
Enter a name in the Tunnel Name field.
For the VPN Tunnel setting, select Enable.
The WAN IP address (A.A.A.A) of the RVL200 will be

automatically detected.
For the Local Security Group Type, select Subnet. Enter

the RVL200’s local network settings in the IP Address

and Subnet Mask fields.

RVL200 IPSec VPN Settings

For the Remote Security Gateway Type, select IP

address. Enter the RV082’s WAN IP address in the IP

Address field.
For the Remote Security Group Type, select Subnet.

Enter the RV082’s local network settings in the IP

Address and Subnet Mask fields.

1.

2.

3.
4.
5.
6.
7.

8.

9.

Advertising