Vinten Radamec Fusion FHR-120 User Manual
Page 21
Operators guide
19
Mounting the payload
When the camera is installed, the remaining payload, including viewfinder and teleprompter, can
be attached to the head. Pan bars cannot be fitted to a fully robotic head.
A teleprompter can be fitted to the head using the mounting bracket supplied with the prompter.
The bracket is fitted into the teleprompter mounting holes [2] on the front of the head and secured
into position using the teleprompter mounting clamps [3].
Attaching an FVR box to the head (FHR-120 VR only)
The FVR box features an integral head mounting bracket which attaches to fixing holes under the
base of the head (Fig. 7).
To mount the FVR box on an FHR-120 VR head, proceed as follows:
1.
Remove the two screws at the rounded end of the base of the head and discard.
2.
Mount the FVR box by placing the bracket against the base of the head. Align the
base and bracket screw holes.
3.
Secure into position using the two long bolts supplied.
Fig. 7 Fitting the FVR box to a head
Warning!
DO NOT attempt to lift or carry the pan and tilt head by the head
mounting bracket.