Vinten Radamec Fusion FHR-120 - Manual (Page 7)

Operators guide
5
Safety instructions
Please read this Operators Guide carefully
before attempting to operate the product.
Retain this guide for future reference.
Safety when working with the
product
Take heed of warnings and
instructions
You should read all of the safety
instructions in this Operators
Guide before attempting to
operate the equipment. Adhere
to all warnings in this guide and
on the equipment. Do not
attempt to operate this
equipment if you do not
understand how to operate it.
Power sources
Connect the product to a power
supply of the type and voltage
rating described in the ‘Technical
data’ section of this Operators
Guide or as marked on the
product.
For an emergency power-down,
ensure all personnel are aware of
the location of the power switch
on the product and associated
equipment and power supplies.
Servicing
Do not attempt to service this
product. Opening and removing
covers may expose you to
dangerous voltages or other
hazards. Refer all servicing to
trained and competent personnel.
Contact Vinten Radamec to
arrange servicing of this product.
!
Water, moisture and dust
Protect the product from water,
moisture and dust. The presence
of electricity near water can be
dangerous. Do not use the
product near water and take care
that liquids are not spilled onto
the equipment.
Operating environment
The product should not be used
outside the operating
temperature limits. To prevent
risk of overheating, ventilate the
product correctly. Refer to the
‘Technical data’ section of this
guide for the operating limits for
the product.
Connections
Turn OFF before connecting or
disconnecting any equipment or
making any adjustments to the
camera or associated equipment.
Safety when working with robotic
equipment
In normal operation remote-controlled
equipment can move suddenly and without
warning. Since audible warnings are not
suitable for use within the studio environment,
it is recommended that only trained personnel
be allowed to work in the active areas where
remote-controlled heads and pedestals are
located. The safe operating zone is a minimum
of 1 m (3 ft). Do not operate robotic equipment,
if you cannot see it.
OFF