Vinten Radamec Fusion FHR-120 User Manual
Page 27
Operators guide
25
4.
After adjusting the C of G height it may be necessary to check that the fore and aft
balance remains satisfactory. Readjust the position of the camera horizontally on the
camera cradle as required.
5.
After balancing, exercise the head through both axes to confirm that it operates
smoothly.
Adjusting the height of the cradle on the tilt axis
1.
Move the cradle [1] to its central (horizontal) position and engage the tilt lock [5].
2.
Mark the fore and aft position of the camera on the camera cradle, so that it can be
reinstalled in the same position, then remove the camera from the cradle.
3.
Loosen the fixing screws securing the camera cradle to the tilt drive [4].
4.
Raise or lower the camera cradle as required.
5.
Tighten the screws to secure the camera cradle into position and refit the camera
between the marks.
6.
Repeat the ‘Checking the C of G height adjustment’ procedure (see above) and adjust
the height of the cradle, if required.
NOTE: Depending on the camera configuration it may be necessary to use an intermediate
plate (part no. 3384-11) to raise the C of G sufficiently to align with the tilt axis.