Vinten Radamec Fusion FHR-120 - Manual (Page 31)

Operators guide
29
Operation
Powering up
When the system is ready, ensure that all external cable connections are complete and the tilt
lock [5] is disengaged before switching the power on.
1. Turn ON the power supply to the head, or to the pedestal or height drive if the head
is powered from that equipment.
2. Switch ON power to the head [13].
The head should not move when power is switched on, but zoom and focus will take up
demanded positions on analogue lenses.The pan and tilt movements of the head are controlled
using the control panel joystick.
Locking the camera cradle
Before making an adjustments to the payload or camera, the tilt lock must be engaged. The tilt
lock prevents the camera cradle from moving on the tilt axis. The tilt lock mechanism is operated
by a button located on the top of the head as shown in Fig. 14.
WARNING!
Ensure that all personnel are clear from the robotic equipment before
switching the power ON. The minimum safe distance is 1 m (3 ft).
Fig. 14 Applying and releasing the tilt lock
Pull button upward to
engage the tilt lock.
Push button downward to
release the tilt lock.