Document Outline

• SP-2000/X-Y Pedestal
• Safety
  • Warning Labels
  • Critical Data For SP-2000/X-Y
• Technical Support
• Warranty
  • Copyright
  • Disclosure Statement - AutoCam System
  • Manual Outline
  • Product Serial Numbers
• Safety & Introduction
  • Safety Issues
    • Pedestal E-STOP Switches
    • Other E-StOP Switches
    • Other Important Information
    • Customer Responsibility
    • Safe Working Environment
    • Safe Operating Zone And Pedestal Footprint
    • Pedestal Active Lights
    • Warning Signs
    • Pedestals And Heads Can Start Unexpectedly
    • Collision Bumper And Bumper Override
      • Bumper Override
    • Pinch Points
    • Sharp Edges
  • Manual Outline
  • The SP-2000/X-Y Servo Pedestal
  • AutoCam Philosophy
    • Seamless Integration Into The Studio
    • “Like Being Behind A Camera”
    • An Easy Transition
  • Typical Applications
    • ACP-8000P System
  • Typical System Configuration
• Operation
  • Introduction
  • Orientation
  • Powering Up The SP-2000/X-Y
    • Powering Down
      • Standby/Charge
      • Stop
  • Emergency STOP Switches
  • Direction Indicators
  • Pedestal Active Lights
  • Using The MCB Controller
    • Local/Remote
    • Drive
    • Rotate
    • Raising/Lowering The Column
  • Targeting
• Installation
  • Introduction
    • Tools You Will Need
  • Floor Preparation For Robotic Pedestals
  • Removing The SP-2000/X-Y From Its Crate
    • Uncrating The Pedestal
    • Unloading The Pedestal
    • AC Powered Unloading
  • Mounting The Pan/Tilt Head & Payload
    • MCB Controller Mounting
  • Pressurizing And Balancing The Pedestal
    • Pressurizing The Pedestal
    • Balancing The Pedestal
    • Finishing Up
    • Discharging The Pedestal
  • Calibrating The Collision Bumpers
  • Electrical Installation And Interconnection
  • Removing The Payload
  • Recrating The Pedestal
    • Crating The Pedestal
• Maintenance And Repair
  • Safety
    • Other Important Information
    • Customer Responsibility
    • Pedestals And Heads Can Start Unexpectedly
    • Pinch Points
    • Sharp Edges
  • Routine Maintenance
    • Cleaning The Targets
      • Removing Targets
    • DC Power
    • Column Balance
    • Overall Operation
    • E-STOP Switch Operation
    • Collision Bumper Operation
    • Removing The Covers
      • The North Cover
      • The West Wheel Cover
      • The East Wheel Cover
      • Replacing The Covers
    • Cleaning The Target Sensors
    • Cleaning The Slip Rings
    • Examining The Wheels
  • Cylinder Replacement
  • Electronics Repair
    • Service Philosophy
    • Safety
  • Calibration
    • Collision Bumpers
    • Target Sensor Calibration
  • Theory Of Operation
    • System
    • Power Bus
    • Data Bus
    • Battery Pack and Power Management
      • Battery Bypass
  • The Targeting System
    • Lowering The Sensors
    • The Sensor Assembly
    • The Dolly Board
    • 4-Channel Servo Boards
      • Analog
      • Digital
    • Brushless Motors
    • Motor Drive Amplifiers