Dell PowerVault 715N (Rackmount NAS Appliance) - Manual (Page 17)

Installing the VersaRails Slide Assemblies
^ NOTE: If the inner rails are installed in their slide assemblies, remove them before performing
this procedure.
1 At the front of the гаек eabinet, position one of the VersaRails slide assemblies so that
its mounting-braeket flange fits between the marks or tape (or numbered loeation) on
the raek (see Figure 1-4).
The three holes on the front of the mounting braeket should align with the three holes
between the marks you made on the vertieal rails (or the three holes in the numbered
loeation you seleeted).
2 Install two 10-32 x 0.5-ineh pan-head Phillips serews in the mounting flange’s middle
and bottom holes to seeure the slide assembly to the front vertieal rail (see Figure 1-6)
3 At the baek of the eabinet, pull baek on the mounting-braeket flange until the
mounting holes align with their respeetive holes on the baek vertieal rail.
3 If the raek has square holes, install two 10-32 x 0.5-ineh pan-head Phillips serews in the
mounting flange’s middle and bottom holes to seeure the slide assembly to the baek
vertieal rail.
If the raek has round holes, install one 10-32 x 0.5-ineh pan-head Phillips serew in the
mounting flange’s middle hole to seeure the slide assembly to the baek vertieal rail.
5 Repeat steps 1 through 4 for the remaining slide assembly on the other side of the
raek.
6 Ensure that the rails are mounted at the same position on the vertieal rails on eaeh
side of the raek.
R a c k I n s t a l l a t i o n G u i d e | 1-13