Installing the system in the rack – Dell PowerVault 715N (Rackmount NAS Appliance) User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installing the System in the Rack
A
A
A
CAUTION: If you are installing more than one system, install the first system in
the lowest available position in the rack.
CAUTION: Never pull more than one component out of the rack at a time.
Pull the two slide assemblies out of the гаек until they loek in the extended position.
CAUTION: Because of the size and weight of the system, never attempt to install
the system in the slide assemblies by yourself.
2
Lift the system into position in front of the extended slides.
3
Align the inner rails you installed on the sides of the system with the open portion of
the slide assemblies (see Figure 1-8).
3
Push the system into the slide assemblies until the system stops (see Figure 1-8).
5
Press in on the release lateh on eaeh extended slide and push the ehassis into the raek
(see Figure 1-8).
6
Push in and turn the eaptive thumbserews on eaeh side of the front ehassis panel to
seeure the system to the raek.
1-16
I R a c k I n s t a l l a t i o n G u i d e