Installing the inner rails, Installing the inner rails -15 – Dell PowerVault 715N (Rackmount NAS Appliance) User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installing the Inner Rails
To install the inner rails to the sides of the system, perform the following steps.
CAUTION: The system may be heavy when fully loaded. To prevent personal
injury, do not attempt to move the system by yourself.
1
Position the inner rail on the side of the system ehassis (see Figure 1-7).
Seeure eaeh inner rail to the side of the ehassis with three 10-24 x 0.375-ineh pan-head
Phillips serews (see Figure 1-7).
Seeure eaeh front mounting braeket to the front-left and front-right sides of the
ehassis using two M3 x 4-millimeter pan-head Phillips serews (see Figure 1-7).
Eaeh front mounting braeket is stamped with L (for left) or R (for right) to indieate on
whieh side of the ehassis (as viewed from the front) you are to install eaeh braeket.
F i g u r e 1 - 7 . I n s t a l l i n g t h e I n n e r R a i l s
R a c k I n s t a l l a t i o n G u i d e
|
1-15