Installation instructions, Installation instructions -2 – Dell PowerVault 715N (Rackmount NAS Appliance) User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
•
Always load the rack from the bottom up, and load the heaviest item in the rack first.
•
Make sure that the rack is level and stable before extending a component from the
rack.
•
Use caution when pressing the component rail release latches and sliding a component
into or out of a rack* the slide rails can pinch your fingers.
•
After a component is inserted into the rack, carefully extend the rail into a locking
position, and then slide the component into the rack.
•
Do not overload the AC supply branch circuit that provides power to the rack.
The total rack load should not exceed 80 percent of the branch circuit rating.
•
Ensure that proper airflow is provided to components in the rack.
Do not step on or stand on any system/component when servicing other
systems/components in a rack.
Installation Instructions
This installation guide provides instructions for trained service technicians installing one or
more systems in a Dell rack cabinet or in a rack cabinet not manufactured by Dell. The
RapidRails™ rack kit can be installed in all Dell rack cabinets and the VersaRails™ rack kit
can be installed in most industry-standard rack cabinets. The procedures for installing both
RapidRails and VersaRails rack kits are similar. One rack kit is required for each system to be
installed in the rack cabinet.
Before attempting this installation, you should read through this entire document carefully.
/K CAUTION: Do not install rack kit components designed for another system. Use
only the rack kit for your system. Using the rack kit for another system may
result in damage to the system and personal injury to yourself and to others.
RapidRails Rack Kit Contents
The RapidRails rack kit includes the following items (see Figure 1-1):
•
One pair of RapidRails slide assemblies
•
One pair of front mounting brackets
•
One cable-management arm
•
Six 10-24 x 0.375-inch pan-head Phillips screws
•
Four M3 x 4-millimeter (mm) pan-head Phillips screws
1-2
I R a c k I n s t a l l a t i o n G u i d e