Routing cables, Routing cables -16 – Dell PowerVault 775N (Rackmount NAS Appliance) User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7
Connect the power cords to their receptacles on the back panel (see Figure 1-10).
Figure 1-10. Routing the Power Cords
/K CAUTION: Allow some slack in each cable as you route them around hinges in the
cable-management arm.
Routing Cables
1
Attach the I/O cable connectors to their respective connectors on the system back
panel.
For details on cable connections, see your system’s Installation and Troubleshooting
Guide and the User’s Guide.
2
Route the power and I/O cables through the cable-management arm, using four
loosely secured tie-wraps (two in the middle and one on each end of the cable-
management arm). Do not fully tighten the tie-wraps at this time (see Figure 1-11).
Allow some cable slack in the cable-management arm to prevent damage to the cables.
3
Secure the cables to the cable-management arm:
a After connecting the cables to the system, unscrew the thumbscrews that secure
the front of the system to the front vertical rail.
b Slide the system forward to the fully extended position.
1-16
I R a c k I n s t a l l a t i o n G u i d e