Four-post rack installation – Dell PowerVault 775N (Rackmount NAS Appliance) User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Rack Requirements for VersaRails
О NOTICE:
The VersaRails rack kit is intended to be installed by trained service
technicians in a rack that meets the specifications of American National
Standards Institute (ANSD/Electronic Industries Association (EIA) standard
ANSI/EIA-310-D-92, International Electrotechnical Commission (lEC) 297, and
Deutsche Industrie Norm (DIN) 41494. One rack kit is required for each system that
is installed in a rack.
Four-Post Rack Installation
Before attempting this installation, you should read through this entire proeedure earefully.
Before You Begin
Before you begin installing your system in the raek, earefully read "Safety Instruetions,"
found earlier in this guide, as well as the safety instruetions found in your system’s System
Information doeument for additional information.
A
!\ CAUTION: When installing multiple systems in a rack, complete all of the
procedures for the current system before attempting to install the next system.
/t\ CAUTION: Rack cabinets can be extremely heavy and move easily on the casters.
The cabinet has no brakes. Use extreme caution while moving the rack cabinet.
Retract the leveling feet when relocating the rack cabinet. Avoid long or steep
inclines or ramps where loss of cabinet control may occur. Extend the leveling
feet for support and to prevent the cabinet from rolling.
Important Safety Information
Observe the safety preeautions in the following subseetions when installing your system in
the raek.
/t\ CAUTION: You must strictly follow the procedures in this document to protect
yourself as well as others who may be involved. Your system may be very large
and heavy, and proper preparation and planning are important to prevent injury
to yourself and to others. This becomes increasingly important when systems are
installed high up in the rack.
Rack Stabilizer Feet
CAUTION: Installing systems in a rack without the front and side stabilizer feet
installed could cause the rack to tip over, potentially resulting in bodily injury
under certain circumstances. Therefore, always install the stabilizer feet before
installing components in the rack.
R a c k I n s t a l l a t i o n G u i d e |
1-3