Replacing the rack doors, Replacing the rack doors -17 – Dell PowerVault 775N (Rackmount NAS Appliance) User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Route the eables along the eable-management arm, make any adjustments
needed to the eable slaek at the hinge positions, seeure the eables to the eable-
management arm with the tie-wraps, and elose the wire eovers over the
eable-management arm.
NOTE:
As you pull the system out to Its furthest extension, the slide assemblies
will lock in the extended position. To push the system back into the rack, press the
slide release latch on the side of the slide, and then slide the system completely
into the rack.
+
Slide the system in and out of the гаек to verify that the eables are routed eorreetly and
do not bind, streteh, or pineh with the movement of the eable-management arm.
5
Tighten the tie-wraps just enough to ensure that the eable slaek is neither too tight to
eause exeessive pinehing nor too loose, yet keep the eables from slipping as the system
is moved in and out of the raek.
Figure 1-11. Routing Cables
Replacing the Rack Doors
Refer to the proeedures for replaeing doors in the doeumentation provided with your raek.
CAUTION: Because of the size and weight of the rack cabinet doors, never
attempt to remove or install them by yourself.
This eompletes the raek installation of your system in a four-post raek eabinet.
R a c k I n s t a l l a t i o n G u i d e |
1-17