MK Diamond MK-101 - Manual (Page 29)

29
MK-101 CleaNUP
NOTe: 1. If an external water source was used, steps A through C may be skipped.
2. Dispose of waste water in accordance with applicable Federal, State and Local laws.
Ensure the saw is disconnected before completing the remainder of the cleanup
process. CAUTION
(D)
Remove the Water Basin
and clean.
(E)
Clean the Movable
Cutting Table Roller Wheel and
Frame Support
Ensure water is not forced into the motor casing when cleaning. CAUTION
(F)
Clean the remainder of the
MK-101
(A)
Clean the Water Pump suc-
tion of all debris. Refer to water
pump manual.
(B)
Place the Water Pump in an
external container
(C)
Run the MK-101 until clear wa-
ter is seen at the blade cooling
ports (Approx. 1 min.)