Mk-101 maintenance – MK Diamond MK-101 User Manual
Page 35
Advertising
35
MK-101
MaiNTeNaNCe
(J)
Push the motor toward the front
of the Cutting Head to loosen
the Micro-V Belt
(K)
Remove the Micro-V Belt
(L)
Install the new Micro-V Belt
(MK Diamond Part No. 158194)
(M)
Verify the Micro-V Belt is seated
in the grooves of both pulleys
(N)
Tighten the Motor Adjustment
Strap to remove slack
(O)
Check Micro-V Belt tension
(proper tension 1/8-inch) Repeat
steps N and O until proper Micro-
V Belt tension is achieved
(P)
Tighten the four motor
mounting bolts
(Q)
Install the Belt Guard
Advertising