Y-cam Cube - Manual (Page 16)

Page 16
3.0 INSTALLATION
For initial setup, you need to connect the Y-cam directly to your router or switch with a network cable. You cannot
connect wirelessly to the camera without first setting it up via a network cable.
You should connect the Y-cam directly in to your internet router (normally supplied by your broadband provider) or a
network switch or hub (that is connected to your computers network).
Using the standard Ethernet network cable, plug this in to the USB to Ethernet cable supplied with your camera. Once connected,
please plug in the USB cable directly into the Y-cam. The USB port will only fit one way so please ensure not force this into the socket
as this may damage the Y-cam and void your warranty.
Using the Power Adaptor (supplied), plug one end in to the Power Connection socket on the Y-cam. Plug the other end in to an
electrical socket and turn the power on.
The Connectivity Status LEDs will light up*. Your router/switch will then begin to communicate with the camera.
You can now proceed to the Software Installation section.