Y-cam Cube - Manual (Page 8)

Page 8
1.4 Maintenance
1. Ensure that the Y-cam and its power source have sufficient ventilation.
2. Do not shake, strike or drop the product.
3. Keep the camera dry and dustless and avoid exposing it to direct sunlight.
4. Do not place the product near any magnetic objects.
5. Avoid putting the product in places where there is constant change in temperature and humidity
6. Keep the product away from heat sources.
7. Do not use the camera near aggressive chemicals.
8. Do not use this camera near water (unless the camera is specified as waterproof).
9. Do not use the camera in the places which are enclosed by metal. The surrounding metal may shield the
electromagnetic waves, and result in failure of signal reception.
10. Please follow your local government environment protection policies.
11. Please turn off the power when left unused.
12. Do not disassemble or attempt to repair the camera; doing so might cause damage to the product and will
invalidate warranty.
Applies to products: YCW005, YCB005, YCWHD5, YCBHD5, YCWHD6, YCBHD6
Please note: Infrared LEDs produce heat. Do not place any objects within 10cm of the LEDs or
allow any object to come in contact with the dome covering the LEDs.