Y-cam Cube - Manual (Page 40)

Page 40
6.6.1.1 Infrastructure Wireless Setup Options
[Security mode] Select the type of security mode that your wireless network is using. None (i.e. off), WEP64, WEP128,
WPA-PSK or WPA2-PSK
Whichever you are using, you will need to enter the settings to connect to your router. Each mode has default settings,
which should suit most installations.
Any “key” it requires is the password you use to access your Wi-Fi / Wireless Connection. You need to enter this twice
so it matches.
Security Mode Options
[Authentication] Select the type of authentication that your router requires.
[Key type] Select the WEP/WPA key type. Either in hexadecimal (Hex) or ASCII characters. Note: Most routers provide
WEP keys in Hex format.
[Encryption type] Select either TKIP or AES for your default encryption setting.
[WEP/WPA key] Type the encryption key that matches that of your router. You will need to enter this twice.
Once you have entered your settings, click “Apply” to save them. If you have entered different keys when retyping them
or the key doesn’t match the length or type of characters required by the encryption type, the camera will notify you.
Once the correct settings are saved, click on “Test” to test the settings. The test will take a few moments to run, and if
your connection can successfully send and receive data, you will get a “success” message.
Note: The settings you enter to connect to your Wi-Fi / Wireless access point or router need to be correct. Please
contact the provider of the Wireless router or access point, or consult the equipment manual on how to verify or modify
these settings.