BendixKing KXP 756 User Manual
Page 22
21
Active Entry
The Active Entry mode is entered
by pushing the Transfer button for
longer than 2 seconds. The
increment/decrement knobs operated
as in Standby Entry, however, the
Standby display is blanked out and
only the Active display as well as the
remote unit is changed by the
increment/decrement knobs.
Momentarily pushing the Transfer
button returns the control unit to
Standby Entry mode. The Standby
frequency or TACAN channel prior to
Active Entry mode remains
unchanged.
Remote Transfer
(Optional Remote Installation)
Grounding the Remote Transfer
line on the rear connector will
exchange the Active and Standby
displays, however, holding the pin at
ground for more than 2 seconds will
not change the mode of the control
unit to Active Entry.
Control Disable
By grounding pin 8, the front
panel and remote controls are made
inoperative.
Default Mode
Depressing the Transfer button or
grounding Remote Transfer while
turning the control unit on will put the
unit in Active Entry mode with a
frequency of 110.00MHz or a TACAN
channel of 37X. Momentarily
depressing the Transfer button will
change the mode of the control unit to
Standby Entry with 110.00MHz or 37X
depending on the mode of the
Standby display. This will aid thje pilot
in blind tuning the radio in case of a
display failure.